Use And Care Manual

• With your hands on the handles (11), push the stand toward
the ground until the tile saw is in an open position with
the release lever (33) locking into place.
FIG. 12e
FIG. 13
Page 30
ASSEMBLY
The dust extraction port (74) is 2-1/2" (6.35 cm) in size
and is located on the back of the table saw. This port
can be connected directly to a dust collection system
by connecting the pick up end of the dust collection hose
to the dust port.
Connect to a dust collection system
(Fig. 13)
11
33
74
WARNING: ALWAYS connect to a dust collection
system. The table saw must be regularly checked for dust
build up and cleaned frequently, otherwise there is a risk of
heat build up and potential re.