Use And Care Manual

Page 27
• Loosen two stop screws (67) on the extension poles (68)
of the outfeed support (5).
• Loosen the locking knobs (69) under the working table
counter-clockwise.
• Insert the rear extension table poles (68) into the two holes
in the rear of the work table and into the extension tube
brackets that are located under the work table. Position
the outfeed support.
• Thread the locking knobs (69) into the the holes under the
work table and tighten them.
• Thread the two stop screws (67) into the holes located on
ends of the extension poles (68) and tighten them.
Outfeed support assembly installation
(Fig. 9a-9b)
The miter gauge (2) can be installed on each miter gauge
groove (70) on either side of blade.
Miter gauge installation (Fig. 10)
FIG. 9a
FIG. 9b
FIG. 10
ASSEMBLY
68
5
67
2
72
69
67
68
68
5
69
67
70
2
70
71
1
2
2
1
4
3
• Remove the miter gauge (2) from storage area (71) located
on inside of the right saw).
• Slide the guide rail (72) of the miter gauge (2) into one of
the guide grooves (70) of the saw table intended for this
purpose.
3
1