Use And Care Manual

Page 26

Rip fence installation (Fig. 8a-8c)

FIG. 8a

FIG. 8b

FIG. 8c

ASSEMBLY

CAUTION: There are three position screws (63, 64,

65) on the each front and rear fence rails (61, 62) to attach

rip fence (6). Position screws (63, 64) use for rip fence on

the right of saw blade. Position screws (65) use for rip fence

on the left of saw blade. (Fig. 8b)

• Loosen the rip fence locking knobs (60) on the rip fence.

• Holding the rip fence (6) at an angle, align the position

screws (front and back) on fence rails with the fence slots

(66).

• Slide the slots (66) onto the position screws and rotate the

fence down until it rests on the rails.

• Secure the rip fence in place by turning the rip fence

locking knobs (60).

• Push down the fence rails locking lever (32) toward the

rear of the saw to unlock it.

• Loosen the rip fence locking knobs (60) on the rip fence.

• Sliding the rip fence (6) to right and swing it up at an

angle, then remove the fence from the front and rear fence

rails (61, 62).

CAUTION: Three position screws apply to three

different scales:

Position screws 63 (AA): Begin with 0 to 24 1/2 in. end.

(Rip fence located on the right of the blade)

Position screws 64 (BB): Begin with 8 in. to 32 1/2 in. end.

(Rip fence located on the right of the blade)

Position screws 65 (CC): Begin with 22 in. to 0 end.

(Rip fence located on the left of the blade)

CAUTION: The rip fence should be parallel to the

saw blade. If not, refer to the section “Aligning rip fence to

blade”.