Use And Care Manual

• Unplug the saw.

• Pull out the knob (53) on the blade guard and push the

blade guard forward to the front of the saw and up until

the pin comes out from the slot in the mounting bracket

(blade guard storage) (54) at bottom rear right side of the

saw, then remove the blade guard from the U-bracket

(blade guard storage) (54) at bottom middle right side of

the saw (Fig. 7a).

• Pull out the knob (53) on the blade guard and place the

pin (55) on the blade guard (3) into the slot (56) marked

on the riving knife (41) and meanwhile align the pin (57) on

the blade guard hole (58) marked on the riving knife (41).

• Pull blade guard fully back onto riving knife and release

the knob (53) to lock guard into position.

• If blade guard is not parallel to table when riving knife is

in uppermost position (through cuts), adjust the set screw

(59) as necessary. (Fig. 7c)

Blade guard installation (Fig. 7a-7c)

FIG. 7a

FIG. 7b

FIG. 7c

Page 25

ASSEMBLY

53 55