Use And Care Manual

CAUTION: This saw is shipped with riving knife in
“MIDDLE” position. Riving knife must be placed in uppermost
position to attach anti-kickback pawls and blade guard for
all through cut operations.
Page 22
37
37
WARNING: Riving knife has three holes for three
positions. The uppermost position is for all through cuts.
The middle position is for non-through cuts (with blade
guard and anti-kickback pawls removed). The down position
is for dado cuts.
34
ASSEMBLY
• To remove the table insert: Turn the lock knob (37) counter-
clockwise to unlock the table insert (38). Place your index
nger in the hole, pulling the table insert (38) out toward
the front of the saw.
• To reinstall the table insert: Push the table insert (38) down,
turn the lock knob (37) clockwis e to lock the table insert
in place.
• When the table insert is not level with the saw table, using
a 2.5mm hex key (not supplied), adjust the four set screws
(39) pre-assembled to the table located on the four holes
of the table insert until the table insert is level with
the working table.
Riving knife installation and position
(Fig. 4a-4c)
FIG. 3b
FIG. 4a
FIG. 4b
40 40
40
36
39
41
41
41
40
To place riving knife in uppermost position (for through
cuts)
• Unplug the saw.
In uppermost position
for through cuts
• Remove the table insert.
• Set the saw blade angle to 0°.
• Raise the saw blade to the uppermost positon by turning
the height adjusting knob (34) clockwise.
• Lock the blade by turning bevel locking lever (36) clockwise.
• Unlock riving knife lock knob (40) by turning it counter-
clockwise.
• Grasp the riving knife (41) and pull toward right side of saw
to release it from spring-loaded locking pin.
NOTICE: The different positions corresponds to different
holes. (E.g. the uppermost position corresponds to bottom
hole.)
In middle position
for non-through cuts
In down position
for dado cuts