Use And Care Manual

WARNING: The table insert must be level with the

saw table. If the table insert is too high or too low, the work-

piece can catch on the uneven edges, resulting in binding

or kickback, which could result in serious personal injury.

WARNING: Be cautious of your hands to avoid being

cut by the saw blade which could result in serious personal

injury when removing or reinstalling the table insert.

Page 21

NOTE: With the stand open, resting on a level surface,

the stand should not move or rock from side to side. If

the stand rocks from side to side, the adjusting feet (19)

need adjusting until the stand is balanced.

ASSEMBLY

• Step on the release lever (33) and pull the handles (11)

toward you at the same time. Once the stand is released

from the release lever, ease the stand toward the oor by

pushing the handles toward the oor.

• With your hands on the handles (11), push the stand toward

the ground until the stand is in an open position.

To remove/replace/align the table insert

(Fig. 3a-3b)

• Lock the blade by turning bevel-locking lever (36) clockwise.

• Lower the blade all the way to down position by turning

the height adjusting knob (34) on the height/bevel adjusting

handwheel (35) counter-clockwise.

FIG. 2j

FIG. 2k

FIG. 3a