Use And Care Manual
Page 17
WARNING: Remove the protective polyfoam from between the saw’s housing and the motor.
CAUTION: This tool is heavy. To avoid back injury, lift with your legs, not your back, and get help when needed.
CAUTION: Many of the illustrations in this manual show only portions of the table saw. This is intentional so that
we can clearly show points being made in the illustrations. Never operate the saw without all guards securely in place and
in good operating condition.
(ITEMS NOT SUPPLIED)
#2 Phillips screwdriver
10mm, 13mm, 16mm wrench
Framing square
Triangle square
2.5mm Hex key
(ITEMS SUPPLIED)
Blade wrench (2 pc)
4mm Hex key (1 pc)
5mm Hex key (1 pc)
UNPACKING YOUR TABLE SAW
YOU WILL NEED
ASSEMBLY
This product requires assembly.
• Carefully lift saw from the carton by the carrying handles located at the each side of the working table of the saw, and
place it on a level work surface.
• Inspect the tool carefully to make sure that no breakage or damage occurred during shipping.
• Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool.
• The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has inuenced the settings,
refer to specic procedures explained in this Operator’s Manual.
• If any parts are damaged or missing, please call 1-877-684-8912 for assistance.
WARNING: The use of attachments or accessories not listed in this manual might be hazardous and could cause
serious personal injury.
WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any
such alteration or modication is misuse, and could result in a hazardous condition leading to possible serious personal
injury.
WARNING: Do not connect to the power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
WARNING: To avoid injury, do not connect this table saw to a power source until it is completely assembled and
adjusted and you have read and understood the operator’s manual.
WARNING: Always make sure the table saw is securely mounted to the stand. Failure to heed this warning can
result in serious personal injury.