Installation Instructions

Page 5
NECESSARY TOOLS REQUIRED
FOR ASSE MB LY
• 10 mm socket
• 14 mm socket
• Extension ratchet
INSTALL THE HANDLE
Position the handle over the holes and
attach with the M6 x 12 hex bolts. Tighten
securely using a 10 mm socket.
INSTALL THE
CORD WRAP
Position the cord wrap over the holes and
attach with the M6 x 12 Phillips head bolts.
TIghten securely.
INSTALL THE
POWER CORD
Cut the black strip holding the cord, then
pull the white strip to get the plug out of the
cabinet and through the grommet. Tighten
the grommet.
INSTALL THE CASTERS
NOTE: Two or more people may be required
to complete this step.
Carefully lay the bottom cabinet on its
back using a soft mat under the back
for protection. Position the four swivel
casters on the left and right outer edges
of the bottom of the cabinet. Insert
M8 x 25 hex bolts through washers, then
through the casters and into the bottom
of the cabinet. Tighten securely using a
14 mm socket. Repeat for the two rigid
casters placing them in the middle of the
cabinet.
ASSEMBLY AND OPERATION