Use And Care Manual

Page 11
OPERATION
b. Presta valve: Remove the tire valve
cap. Open the valve tip. Thread the
presta valve adaptor on to the valve
stem. Move the tire inflator lever straight
up and push it over the presta valve
adaptor. Move the lever to the locked
position.
4. Press the mode button to turn on the
pressure gauge.
5. Select the pressure unit by pressing
the mode button until the desired unit
is displayed (PSI, BAR or kPa). Set
the pressure by pressing the “+” or
“–” button until the proper pressure is
displayed.
6. To start inflating, press the power switch
to the high-pressure position (I).
7. To stop inflating, press the power switch
to the off position (O).
8. When finished, move tire inflator’s lever
straight up and then remove the tire
inflator.
9. Turn off the tool by pressing and holding
the mode button. Unplug or remove the
battery pack after use.
NOTICE: Make sure the tire inflator is firm-
ly locked in place before starting inflation.
WARNING:
To prevent serious
injury and death from explosion, do
not overinflate. Do not leave the tool
unattended while inflating.
INFLATING SMALL INFLATABLES
(FIG.6)
FIG. 6
Tapered
Adaptor
1. Remove the high-pressure hose from its
storage area.
2. Move tire inflator lever straight up and
insert adaptor. Move the lever to the
locked position.
3. Connect the adaptor to the item to be
inflated.
4. Press the mode button to turn on the
pressure gauge.
5. To start inflating, press the power switch
to the high-pressure position (I).
6. To stop inflating, press the power switch
to the off position (O).
7. When finished, move tire inflator lever
straight up and then remove the adaptor.
8. Turn off the tool by pressing and holding
the mode button. Unplug or remove the
battery pack after use.
Ball Needle
Adaptor