Use And Care Manual

Page 13
The maximum weight
for each drawer should be no more than
100 lbs
ASSEMBLY AND OPERATION
4-DRAWER BASE CABINET
Carefully lay the cabinet on its back on a
soft surface to protect the finish. Screw the
four adjustable feet onto the bottom of the
cabinet.
To remove a drawer, pull the drawer out so
it is almost fully extended. PUSH UP ON
THE RIGHT hand black release lever, while
PULLING DOWN ON THE LEFT hand black
release lever. While holding the levers in
the positions as instructed above, pull the
drawer outward until it is released from the
drawer slide.
PUSH UP (RIGHT HAND SIDE)
PULL DOWN (LEFT HAND SIDE)
To replace a drawer, extend the drawer
slides from the cabinet. Insert the brackets
on each side of the drawer into the slots in
the cabinet slides, BEING CAREFUL THAT
THEY ARE POSITIONED PROPERLY.
Once properly inserted, completely close
the drawer to set the slides in their proper
positions.
CAUTION: