Assembly Instructions

Page 10 Page 11
ASSEMBLY AND OPERATION
Attach the bottom panel to the cabinet
using eleven M6 x 16 Phillips head bolts.
Insert four shelf supports inside the cabinet
at the desired height.
Place the shelf on the shelf supports.
The cabinet weight capacity is determined
by the stability of the surface it is mounted to.
FOR BEST RESULTS, WALL CABINETS
SHOULD BE MOUNTED TO STUDS OR
OTHER SOLID SURFACES. Do not mount
to drywall as it will not support the required
weight and poses a danger if mounted
incorrectly.
Attach the mounting bracket to the wall at
the desired height using two M6 x 40 hex
tapping screws, making sure the bracket is
level.
Hang the wall cabinet on the mounting
bracket.
Fasten the wall cabinet to the wall with
a M6 x 65 hex tapping screw and washer.
ASSEMBLY AND OPERATION
2-DOOR WALL CABINET
Carefully separate the front and back
panels, allowing the side panels to unfold
completely.
Attach the top panel to the cabinet using
eight M6 x 16 Phillips head bolts.
Carefully lay the cabinet on its back on a
soft surface to protect the finish.
INSERT THE LIP OF THE BOTTOM
PANEL INTO THE SLOT ON THE BACK
OF THE CABINET, MAKING SURE THAT
THE HOLES ALIGN.
TILT THE BOTTOM PANEL ONTO THE
BOTTOM OF THE CABINET.
Continue on the next page
Assembly is VERY EASY, however there are a few key steps that must be followed.
THESE KEY STEPS ARE HIGHLIGHTED IN BOLD CAPS. FOLLOW THESE TO EXPEDITE ASSEMBLY.
The maximum shelf
capacity should be no more than 50 lbs
CAUTION: