Use And Care Manual

Page 11
NOTE:
The provided filter can be used for both
wet and dry vacuum operation.
1. Verify that the cartridge filter is securely
mounted (Fig. 18). For installation
instructions see page 16.
Fig. 18
2. Insert the hose into the vacuum port
(Fig. 19).
Fig. 19
3. Push required accessories onto the free
end of the hose or the extension wand
(Fig. 20).
Fig. 20
4. Make sure the battery pack is correctly
installed (Fig. 21). For installation
instructions see page 8.
Fig. 21
5. Turn the motor on by flipping the switch to
the 'I' ON position (Fig. 22).
Fig. 22
6. Once you have completed vacuuming, or
when the tank is full, turn the motor off by
f lipping the switch to the 'O' OFF position
(Fig. 23).
Fig. 23
LIQUID VACUUM OPERATION