Use And Care Manual

Page 11
OPERATION
LED WORKLIGHT (FIG.5)
FIG. 5
The LED worklight, located on the base of the
hammer drill, will illuminate when the trigger
switch is depressed before the hammer drill
is running. This provides additional light on
the surface of the workpiece. The light will
automatically turn off within 10 seconds
after the trigger is released.
VARIABLE-SPEED TRIGGER
SWITCH (FIG. 6)
FIG. 6
1. To turn the hammer drill ON, press the
variable-speed trigger switch.
2. To turn the hammer drill OFF, release the
variable-speed trigger switch.
3. The variable-speed trigger switch
delivers higher speed with increased
trigger pressure and lower speed with
decreased trigger pressure.
WARNING:
Allow the motor to
come to a complete stop before setting
the hammer drill down.
ELECTRIC BRAKE
To stop the hammer drill, release the
variable-speed trigger switch and allow
the chuck to come to a complete stop. The
electric brake quickly stops the chuck from
rotating. This feature engages automatically
when the trigger switch is released.
DIRECTION-OF-ROTATION
SELECTOR
(FORWARD/CENTERLOCK/
REVERSE) (FIG. 7)
FIG. 7
The direction of bit rotation is reversible and
is controlled by a selector located above the
trigger switch. With the hammer drill held in
normal operating position:
1. Position the direction-of-rotation
selector to the right of the tool for
reverse rotation.
LED Worklight
Variable-Speed
Trigger Switch
ForwardReverse
Direction-
Of-Rotation
Selector