Use And Care Manual

Page 9
2. Depress the battery-release button,
located on the front of the battery pack,
to release the battery pack.
3. Pull the battery pack and remove it from
the tool.
VARIABLE-SPEED TRIGGER
SWITCH (FIG. 2)
FIG. 2
1. To turn the drill/driver ON, press the
trigger switch.
2. To turn the drill/driver OFF, release the
trigger switch.
3. The variable-speed trigger switch
delivers higher speed with increased
trigger pressure and lower speed with
decreased trigger pressure.
WARNING:
Allow the motor to
come to a complete stop before setting
the drill/driver down.
DIRECTION -OF-ROTATION
SELECTOR (FORWARD/CENTER-
LOCK/REVERSE) (FIG. 3)
FIG. 3
Reverse
The direction of bit rotation is reversible and
is controlled by a selector located above the
trigger switch. With the drill/driver held in
normal operating position:
1. Position the direction-of-rotation
selector to the right of the tool for
reverse rotation.
2. Position the direction-of-rotation
selector to the left of the tool for forward
rotation.
3. Setting the direction-of-rotation selector
in the OFF (center-lock) position helps
reduce the possibility of accidental
starting when not in use.
NOTICE: To prevent gear damage, always
allow the drill/driver to come to a complete
stop before changing the direction of rota-
tion.
NOTICE: The drill/driver will not run unless
the direction-of-rotation selector is en-
gaged fully to the left or right.
OPERATION
Variable-speed
Trigger Switch
Forward
Direction-
of-rotation
Selector