Use And Care Manual

Page 9
TRIGGER SWITCH (FIG.2)
To turn the impact driver on, depress the
trigger switch.
To turn it off, release the trigger switch.
VARIABLE SPEED
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
DIRECTION-OF-ROTATION SE-
LECTOR (FORWARD/CENTER-
LOCK/REVERSE) (FIG.3)
The direction of rotation is reversible and is
controlled by a selector located above the
trigger switch. With the impact driver held
in normal operating position: position the
direction-of-rotation selector to the left of
the tool for forward rotation; position the
direction-of-rotation selector to the right
of the tool for reverse rotation. Setting the
switch in the OFF (center-lock) position
helps to reduce the possibility of accidental
starting when not in use.
NOTICE: To prevent gear damage, always
allow the impact driver to come to a com-
plete stop before changing the direction of
rotation.
NOTICE: The impact driver will not run un-
less the direction of the rotation selector is
engaged fully to the left or right.
MODE SELECTOR (FIG.4)
NOTICE: The impact driver is designed
with 3-speed and auto-stop functions;
these functions are available only when the
tool is operating in forward rotation.
NOTICE: The mode can only be changed
when the mode-indicator light is on. The
mode-indicator light will be off automati-
cally in about one minute.
1. Attach the battery pack to the impact
driver.
ASSEMBLY
Direction-of-
rotation Selector
Trigger Switch
FIG. 2
Reverse
Forward
FIG. 3
L
AUTOSTOP
H
Mode Selector
Mode Indicator
Auto-stop
Indicator
FIG. 4