Technical Specifications

Page 7
TURNING THE AREA LIGHT ON
AND OFF (FIG. 2)
FIG. 2
Switch Button
OPERATION
WARNING:
Do not at any time let
brake uids, gasoline, petroleum-based
products, penetrating oils, etc. come in
contact with plastic parts. Chemicals can
damage, weaken or destroy plastic, which
may result in serious personal injury.
MAINTENANCE
The tool may be cleaned most effectively
with compressed dry air. Always wear
safety goggles when cleaning tools with
compressed air.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their use.
Use a clean cloth to remove dirt, dust, oil,
grease, etc.
MAINTENANCE
1. Press the switch: the light is on at 360°
high illumination mode.
2. Press the switch again: the light is on at
360° low illumination mode.
3. Press the switch button a third time and
the light will produce 180° illumination.
4. Press the switch again to turn the light is
off.
UTILITY HOOK
Your light is equipped with a convenient
utility hook for hanging your light. To use,
simply lift the hook until it snaps into the
open position. When not in use, always lower
hook until it snaps into the closed position.
BEFORE EACH USE
1. Check for damaged, missing, or worn
parts.
2. Check for loose screws, misalignment
or binding of moving parts, or any other
condition that may affect the operation.
3. If abnormal vibration or noise occurs,
turn the tool off immediately and have
the problem corrected before further
use.