Technical Specifications

Page 10
OPERATION
VARIABLE‐SPEED TRIGGER
SWITCH (FIG. 5A & 5B)
Your reciprocating saw is equipped with a
trigger switch to turn the saw on and off and
to control the speed.
1. Before you turn on the tool, open the
lock-off button by pressing from the
right side (FIG. 5A).
FIG. 5A
Close
Lock-off Button
Open
2. To turn the saw on, depress the trigger
switch (FIG. 5B).
FIG. 5B
Trigger Switch
3. To turn the saw off, release the trigger
switch.
4. The variable-speed trigger switch
delivers higher speed with increased
trigger pressure and lower speed with
decreased trigger pressure.
NOTICE: Engage the lock‐off button by
pressing from the left side when the tool
is not in use.
ADJUSTING THE BLADE ORBIT
ACTION (FIG. 6)
This reciprocating saw has the option of
orbit action to make the blade swing slightly
as it cuts. Maximum cutting efficiency can
be obtained by adjusting the blade orbit
selector lever to orbital action.
1. Remove the battery pack from the tool.
2. Turn the orbit selection lever to the
“
” position for orbital cutting action.
3. Turn the orbit selection lever to the
“ ” position for straight cutting
action.
FIG. 6
Blade-Orbit Selection Lever
LED WORKLIGHT (FIG. 7)
Your reciprocating saw has two built-in
LED worklights for illuminating the cutting
area. To activate the LED worklight, open
the lock-off button and depress the trigger
switch. The light will automatically turn off
within 10 seconds after releasing the trigger.
FIG. 7
LED Worklight