Technical Specifications

Page 15
OPERATION
BEVEL CUTTING (FIG. 13)
1. Remove the battery pack from the tool.
2. Adjust the angle of cut to any desired
setting, between 0° and 56,° according
to the section “ADJUSTING THE
CUTTING ANGLE”.
3. Replace the battery pack.
4. Align the cutting line with the 45° blade-
guide notch on the base shoe when
making 45° bevel cuts.
5. Make a trial cut in scrap material along
a guideline to determine the amount to
offset the notch on the cutting material.
6. Hold the saw firmly with both hands.
7. Rest the front edge of the base shoe
on the workpiece without touching the
blade to the workpiece.
8. Start the saw and allow the blade to
reach full speed.
9. Guide the saw into the workpiece, and
make the cut.
10. Release the trigger switch and allow the
blade to come to a complete stop.
11. Lift the saw from the workpiece.
WARNING:
Attempting a bevel cut
without having the bevel-locking knob
securely locked in place can result in
serious injury.
FIG. 13A
45° Indicator
45° Indicator
Line of Cut
FIG. 13B