Technical Specifications

Page 11
ASSEMBLY
ADJUSTING THE CUTTING
ANGLE (FIG. 4)
FIG. 4
Bevel Angle
Scale
Bevel-adjustment
Lever
The saw is equipped with a 45° stop to
quickly set up for 45° bevels. To set a 45-56°
bevel, raise the stop.
1. Remove the battery pack from the tool.
2. Loosen the bevel-adjustment lever,
located on the 0°-56° bevel scale.
3. Tilt the body of the saw until the indicator
mark on the saw aligns with the required
angle on the bevel angle scale.
4. Tighten the bevel-adjustment lever to
secure the saw.
0° BEVEL STOP
The saw has a 0° bevel stop that has been
adjusted before shipment to assure that the
blade is vertical to the base at the 0° bevel
setting.
TO CHECK 0° BEVEL
STOP (FIG. 5)
1. Remove the battery pack from the tool.
2. Using a square ruler (available
separately), check the squareness of
the saw blade to the base of the saw.
FIG. 5
Square Ruler
Saw Blade
Base
TO ADJUST 0° BEVEL
STOP (FIG. 6)
1. Remove the battery pack from the tool.
2. Loosen the bevel-adjustment knob.
3. Use a hex wrench (available separately)
to turn the adjusting screw until the
base is square with the saw blade.
FIG. 6
Adjusting
Screw