Assembly Instructions

1111
..
..
..
...
...
... ...
.. ..
... ... ...
ASSEMBLY INSTRUCTIONS
MOUNTING THE MITER SAW TO THE STAND
1. Now that the 26" x 19" STEEL TABLE TOP is mounted to a pair of RAPID CLAMP TOOL
MOUNTS, lift the unit, allowing the assembly to tilt slightly toward your body.
2. While still tilted toward you, hook the front edge of the tool mount assembly onto the front
rail of the stand.
3. Lower the tool mount assembly to allow the rear edge of the tool mount to seat fully over the rear rail.
4. Lock the tool mounts in position by lowering the locking levers.
5. Snap the J-Lock
™
closed (around the beams) to prevent your mounted tool from detaching from the
MASTERFORCE
®
Miter Saw Station. Your table is now ready for use (Figure 4).
FIG 4
Page 5
GENERAL SAFETY INSTRUCTIONS
Figure 1.
Using power tools of any kind can be dangerous if safe operating procedures are not followed.
Recognizing the hazards of each tool and using them with respect and caution will considerably
limit the possibility of personal injury. However, if safety precautions are ignored, personal injury
will likely result. Always use common sense - your personal safety is your responsibility.
1. Know your power tool. Read and understand the Operator's Manual and observe the
warnings and instruction labels affixed to the tool.
2. Properly ground all tools.
3. Keep guards in place.
4. Remove adjusting keys and wrenches.
5. Keep work area clean and dry.
6. Keep children away.
7. Never leave running machines/tools unattended.
8. Disconnect tools from service.
9. Use correct tools for the job.
10. Never force a tool.
11. Wear safety apparel.
12. Wear safety glasses/goggles.
13. Never stand or sit on tools.
14. Replace damaged components immediately.
15. Make sure your work platform is sufficiently sturdy to do the specific job at hand.
16. Properly anchor blade for job being done.
17. Use correct blade for job being done.
18. Think Safety. Safety is a combination of operator awareness, common sense and
alertness at all times.
OVERVIEW
You have purchased a 26" x 19" STEEL TABLE TOP. This product has been specifically designed
to mount on to any MASTERFORCE
®
Miter Saw Stand. The 26" x 19" STEEL TABLE TOP is made
from steel with a gold-iridite, zinc-plated finish for corrosion resistance. The unit sets up fast and
removes easily for job productivity. The 26" x 19" STEEL TABLE TOP can be used in conjunction
with the MXSJ1 (242-1502) Surface Weld Clamp, MXSJ2 (242-1503) Inline Welding Clamp and
the MX36/26 5pc Adjustable Fence and Stop (242-1501) designed for common ¾" peg holes
(sold separately).
FIG 1
TOP VIEW
BOTTOM VIEW
Page 2