Assembly Instructions

ManualsBrandsMasterforce ManualsTools26" x 19" Steel Welding Tabletop

® ® ®

® ® ® ®

26" x 19" STEEL TABLE TOP

240-1676

OPERATOR’S MANUAL

CAUTION:

To Reduce The Risk Of Injury, User Must Read And

Understand Operator’s Manual. Save These Instructions For Future Reference.

For questions / comments, technical assistance or repair parts -

10/05/2016

Please call toll free at: 1-800-255-7011 ( M-F 8am - 6pm CST)

Summary of content (4 pages)

PAGE 1
~- ~ 26" x 19" STEEL TABLE TOP ® ® ® ® ® ® ® ® ® ® ® ® ® ® ® ~- !-- I 240-1676 OPERATOR’S MANUAL © 2016 Menard, Inc., Eau Claire, WI 54703 10/05/2016 u CAUTION: To Reduce The Risk Of Injury, User Must Read And Understand Operator’s Manual. Save These Instructions For Future Reference.
PAGE 2
TABLE OF CONTENTS Save this Manual.............................................................................. Page 1 Safety ...............................................................................................Page 1 Parts List...........................................................................................Page 1 General Safety .................................................................................Page 2 Overview................................................................
PAGE 3
ASSEMBLY INSTRUCTIONS GENERAL SAFETY INSTRUCTIONS MOUNTING THE MITER SAW TO THE STAND 1. Now that the 26" x 19" STEEL TABLE TOP is mounted to a pair of RAPID CLAMP TOOL MOUNTS, lift the unit, allowing the assembly to tilt slightly toward your body. 2. While still tilted toward you, hook the front edge of the tool mount assembly onto the front rail of the stand. 3. Lower the tool mount assembly to allow the rear edge of the tool mount to seat fully over the rear rail. 4.
PAGE 4
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS ASSEMBLING YOUR STEEL TABLE TOP 1. Remove all parts from the box and place them on the floor. 2. Take the STEEL TABLE TOP (part 1) and place it on the floor with the top portion on the bottom. Be sure to choose a surface that will NOT damage the table top. 3. Locate the pre-drilled holes along the edges of the beams on the bottom of the STEEL TABLE TOP (two per side).