Installation Instructions

5. Repeat through the other end of the tool mount.
6. Place the second tool mount underneath the other side of the tool, aligning the mounting
holes and repeat steps 1 thru 5 on the miter saw base with the opening in the tool mount.
7. After making sure both tool mounts are parallel to each other, tighten all four nuts to hold in
position.
NOTE: If the tool has holes that do not line up with the slots in the tool mounts, then use the
Offset Mounting Brackets. See Figure 4.
Offset Mounting Brackets
Page 7
MOUNTING INSTRUCTIONS
IMPORTANT: Prior to mounting your 5-in-1 to a stand or surface, first attach your power tool to
both Rapid Clamp Tool Mounts with the black, bolted-on handles facing outward. Install a
washer onto the larger bolts (included). Insert the bolts through the holes on your power tool
and then through the slats in the Rapid Clamp Mounts. Finish by installing a Lock Washer and
Nut, and then tighten with a 3/8" Box Wrench. Repeat until your tool is secured.
Next, mount your 5-in-1 bracket according to the intended use:
1. Miter saw installations
a. Ensure the black Rapid Clamp Handles are in the open position (parallel to the body of the
Rapid Clamp Mounts) and place them onto the Mounting Beams. These handles pivot
with a 90-degree arc.
b. Lock the Mounts onto the back Mounting Beam first, and then the front (the handles will be
farthest away from you).
c. Swing the pivoting handles downward into the closed position perpendicular to the body
of the Rapid Clamp Mounts.
d. Snap the J-Lock
™
closed (forward) around the beams to prevent your mounted tool from
detaching from the Masterforce
®
5-ln-1 Miter Saw Station.
2. Wall-mounting scenarios
a. Use only the Rapid Clamp Tool Mounts included with this kit featuring the J-Lock
™
Clip.
Without this unique clip, it is possible that your tool could become dislodged from the
mount if bumped.
b. Ensure the black Rapid Clamp Handles are in the open position (parallel to the body of the
Rapid Clamp Mounts) and place them onto the Mounting Beams.
c. Holding the Rapid Clamp Tool Mounts with the pivoting handles facing upward, hold the
assembly by the outward-facing permanent handles and place the unit onto the top
Mounting Beam.
d. Next, firmly press the bottom portion into place until it snaps onto the beam.
e. Swing the top handles forward (away from you) into the closed position perpendicular to
the body of the Rapid Clamp Mounts.
f. Snap the J-Lock
™
closed (downward) around the beams to prevent your mounted tool from
detaching from the Masterforce
®
5-ln-1 Miter Saw Station.
3. Saw horses/2x4’s
a. Place the Universal Quick-Mount Tool Station over the MX042 or MX047 saw horse. When
installed correctly, the square-shaped hole in the bracket will straddle the top of the
sawhorse.
b. For wooden saw horses or 2x4 installations, use wood screws or similar hardware to
attach the Universal Quick-Mount Tool Station to the frame (not included). Holes are
drilled into the metal framework for this purpose.
c. Ensure the black Rapid Clamp Handles are in the open position (parallel to the body of the
Rapid Clamp Mounts) and place them onto the Mounting Beams. These handles pivot
with a 90-degree arc.
d. Lock the Mounts onto the back Mounting Beam first, and then the front (the handles will be
farthest away from you).
Page 8