Installation Instructions

-
l
g
MOUNTING INSTRUCTIONS
e. Swing the pivoting handles downward into the closed position perpendicular to the body
of the Rapid Clamp Mounts.
f. Snap the J-Lock
™
closed (forward) around the beams to prevent your mounted tool from
detaching from the Masterforce
®
Universal Quick-Mount Tool Station.
4. Surfaces/work tables
a. Place the Mounting Plates onto your intended mounting surface (See Fig. 1, Pg.3). With a
marker, trace the inside of the machined holes. Remove the plates and pre-drill holes for
mounting hardware. Then align bolt mounting holes with pre-drilled holes.
b. Use appropriate mounting hardware to attach the Universal Quick-Mount Tool Station to
the frame (not included). Holes are drilled into the metal framework for this purpose. Be
sure not to over tighten.
c. With the black Rapid Clamp Handles in the open position (parallel to the body of the
Rapid Clamp Mounts), place them onto the Mounting Beams. These handles pivot with
a 90-degree arc.
d. Lock the Mounts onto the back Mounting Beam first, and then the front (the handles will be
farthest away from you).
e. Swing the pivoting handles downward into the closed position perpendicular to the body
of the Rapid Clamp Mounts.
f. Snap the J-Lock
™
closed (forward) around the beams to prevent your mounted tool from
detaching from the Masterforce
®
Universal Quick-Mount Tool Station.
FIG 2
5. Freestanding
a. Ensure the black Rapid Clamp Handles are in the open position (parallel to the body of
the Rapid Clamp Mounts), and place them onto the Mounting Beams. These handles
pivot with a 90-degree arc.
b. Lock the Mounts onto the back Mounting Beam first, and then the front (the handles will
be farthest away from you).
c. Swing the pivoting handles downward into the closed position perpendicular to the body
of the Rapid Clamp Mounts.
d. Snap the J-Lock
™
closed (forward) around the beams to prevent your mounted tool from
detaching from the Masterforce
®
Universal Quick-Mount Tool Station.
Page 9
ASSEMBLY INSTRUCTIONS
ATTACHING YOUR MITER SAW OR OTHER BENCH TOP POWER TOOLS
Various bench top tools can be attached to the Rapid Clamp Tool Mounts. Always position the
tool to achieve maximum balance and stability. All four corners of the saw must be bolted to the
tool mounts before use. Make sure the bolts do not extend above the table of the miter saw.
1. Unplug all tools and lock down any moving parts.
2. Select a Storage Handle and position it where desired on one mounting rail. Run two
M8*20 Carriage Bolts through the slots in the rail arms and attach using a #8 washer and
nut. These handles are designed to store tools and can be located where most convenient
for the user by sliding it along the rail. See Figure 2. Tighten the bolts and repeat for the
second arm. The handles should face opposite directions (outward) when the two
completed arms are next to each other.
Rapid Clamp Tool
Mount Base
Rapid Clamp Tool
Mounting Rail
Rapid Clamp Tool
Handle and Tool
Storage Arm
3. Feed a carriage bolt up through the tool mount and the mounting hole in the power tool.
See Figure 3.
4. Secure in place using a flat washer, lock washer and nut.
Page 6