Installation Instructions

PARTS LIST
0 0 0
0
0
0
1
2
3
4
9
5
6
7
8
10
Tool Mount
Adjustment Screw
'*''
Wrench
MAINTENANCE
TO ADJUST:
1. Use a wrench to slightly loosen the nut.
2. Turn the screw with a Phillips screwdriver. Rotate clockwise, if the tool mount assembly needs to
be tightened. Rotate counterclockwise if the assembly needs to be loosened. See Figure 6.
3. Install the tool mount on the miter stand rails and lower the locking lever to check the adjustment.
4. When the correct position is achieved, wrench tighten the nut to secure.
5. Repeat with the second tool mount.
M8 Nut
GENERAL MAINTENANCE
Avoid using solvents when cleaning. Most items are susceptible to damage from various types
of commercial solvents. Use clean clothes to remove dirt, dust, oil, grease, etc.
PART #
1
2
3
4
5
6
7
8
9
10
DESCRIPTION
Rapid Clamp Tool Mounts
Offset Mounting Brackets
Nut M8
Spring Washer #8
Washer #8
Carriage Bolt M8*50
Carriage Bolt M8*20
Storage Handles
Mounting Plates
Mounting Beams
QTY
1 set
2 pcs
10 pcs
10 pcs
10 pcs
4 pcs
6 pcs
2 pcs
2 pcs
2 pcs
Page 11
Page 4