Universal Quick-Mount Tool Station ® 4 £ : l R J ,i F A E T S l [M/f 240-1675 OPERATOR’S MANUAL [ACAUTION:JTo Reduce The Risk Of Injury, User Must Read And © 2016 Menard, Inc., Eau Claire, WI 54703 03/14/2017 Understand Operator’s Manual. Save These Instructions For Future Reference.
TABLE OF CONTENTS NOTES Save this Manual.............................................................................. Page 1 General Safety Information............................................................... Page 1 Work Area Safety.............................................................................. Page 1 Personal Safety.................................................................................Page 2 Tool Use and Page 2 Care..........................................................
NOTES PERSONAL SAFETY • Stay alert, watch what you are doing and use common sense when operating near power tools. Do not use tools while tired or under the influence of drugs, alcohol, or medications. A moment of inattention while operating power tools may result in serious personal injury. • Dress properly. Do not wear loose clothing or jewelry. • Contain long hair. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts.
SAFETY INSTRUCTIONS FOR POWER TOOLS Using power tools can be dangerous if safe operating procedures are not followed. Recognizing the hazards of each tool and using them with respect and caution considerably limits the possibility of personal injury. However, if safety precautions are ignored, personal injury will likely result. Always use common sense – your personal safety is your responsibility. 1. Know your power tool.
PARTS LIST MAINTENANCE TO ADJUST: PART # 1. Use a wrench to slightly loosen the nut. 2. Turn the screw with a Phillips screwdriver. Rotate clockwise, if the tool mount assembly needs to be tightened. Rotate counterclockwise if the assembly needs to be loosened. See Figure 6. 3. Install the tool mount on the miter stand rails and lower the locking lever to check the adjustment. 4. When the correct position is achieved, wrench tighten the nut to secure. 5. Repeat with the second tool mount.
MOUNTING INSTRUCTIONS ASSEMBLY INSTRUCTIONS Required Tools: Phillips Head Screwdriver, Hex Key Wrench (Included), Box Wrench 2x4 Mounted Sawhorse Mounted Work Tables Wall Mounted 1. Carefully remove the contents of the box and place the materials on a flat surface (table, floor, etc.). 2. Identify the included parts: Mounting Beams (2), Rapid Clamp Tool Mounts (2), Mounting Plates (2) and Hardware.
MOUNTING INSTRUCTIONS ASSEMBLY INSTRUCTIONS e. Swing the pivoting handles downward into the closed position perpendicular to the body of the Rapid Clamp Mounts. ATTACHING YOUR MITER SAW OR OTHER BENCH TOP POWER TOOLS f. Snap the J-Lock™ closed (forward) around the beams to prevent your mounted tool from detaching from the Masterforce® Universal Quick-Mount Tool Station. Various bench top tools can be attached to the Rapid Clamp Tool Mounts.
5. Repeat through the other end of the tool mount. 6. Place the second tool mount underneath the other side of the tool, aligning the mounting holes and repeat steps 1 thru 5 on the miter saw base with the opening in the tool mount. 7. After making sure both tool mounts are parallel to each other, tighten all four nuts to hold in position. NOTE: If the tool has holes that do not line up with the slots in the tool mounts, then use the Offset Mounting Brackets. See Figure 4.
