Installation Instructions

ASSEMBL V INSTRUCTIONS
Required Tools: 13mm Box End Wrench (when mounting)
1. Carefully remove the contents of the box and place the materials on a flat surface (table,
floor, etc.).
2. Attach the Mounting Brackets to two Rapid Clamp Tool Mounts (sold separately , 240-1659)
using a ratchet with 3mm Box End Wrench to tighten the four carriage bolts (included) or
other appropriate mounting hardware.
Pages
SAVE THIS MANUAL
Reference this manual for all safety warnings and precautions, operating and maintenance
procedures, parts list and diagrams. Keep your invoice with this manual and write your invoice
number on the inside of the front cover . Keep the manual and invoice in a safe, dry place for
future reference .
IAWARNING:I Be sure to read and understand all safety instructions in this manual ,
including all safety alert symbols such as "danger", "warning", and "caution" before using
this tool. Failure to follow all instructions may result in serious personal injury.
OVERVIEW
You have just purchased an Oversized Tool Mount Table Accessory . This product has been
specifically designed to be used to mount various tools and materials to its surface . Attach the
table to your Universal Mounting Brackets, and then to your Miter Saw Stand.
DESCRIPTION
This Oversized Tool Mount Table Accessory is constructed of extra-heavy gauge, rust-resistant
steel that allows mounting of most power tools and miter saws. It includes two Mounting
Adapters to allow use with most miter saws.
SAFETY INSTRUCTIONS
GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS
Using power tools of any kind can be dangerous if safe operating procedures are not followed.
Recognizing the hazards of each tool and using them with respect and caution considerably
limit the possibility of personal injury. However, if safety precautions are ignored, personal injury
will likely result. Always use common sense - your personal safety is your responsibility .
1. Know your power tool. Read and understand the Product Manual, and observe the warnings
and instruction labels affixed to the tool.
2. Remove adjusting keys and wrenches .
3. Keep work area clean and dry.
4. Keep children away .
5. Wear safety glasses/goggles.
6. Never stand or sit on tools.
7. Replace damaged components immediately.
8. Make sure your work platform is sufficiently sturdy to do the specific job at hand.
IAWARNING:I If you are mounting power tools to your Oversized Tool Mount Accessory ,
make sure it is well balanced and well secured to your miter saw stand to ensure it is stable and
safe to use.
NOTE: The Oversized Tool Mount accessories are not included .
Page2