Product Manual

Page 10
OPERATION
LED WORKLIGHT (FIG. 5)
FIG. 5
LED
Worklight
The LED worklight, located on the base of
the Impact Driver, will illuminate when the
trigger switch is depressed. This provides
additional light on the surface of the
workpiece for operation in lower-light areas.
The light will automatically turn off within 10
seconds after releasing the trigger.
INSTALLING THE BELT
CLIP (FIG. 6)
FIG. 6
Belt clip
1. Align the rib of the belt clip with the hole
on the base of the driver.
2. Insert the screw and tighten the screw
securely with a screwdriver.
REMOVING THE BELT CLIP
1. Use a screwdriver to loosen the screw
that attaches the belt clip to the driver.
2. Remove the screw and the belt clip.
BIT STORAGE (FIG. 7)
FIG. 7
Bit
storage
When not in use, the bit may be stored on
the cordless driver by snapping the bit into
place in the bit clip.