Assembly Instructions

Page 6
CHEST AND CABINET
CONNECTION
WARNING:
(Where applicable)
When adding a chest, all add-on tops must
be removed from the roller cabinet. Make
sure that both connector brackets are in
place and secure.
NOTE: Two or more people may be required
to complete this step.
Place the chest on the cabinet. Attach the
connectors, making sure the connectors
slide into the openings on the back of the
chest. Fasten the connectors to the back
of the cabinet with screws.
RAISE AND RELEASE
DRAWER FRONTS
This unit is equipped with raise and release
drawer fronts.
To open, lift up on the drawer front while
pulling towards you.
To close, shut the drawer firmly until the
latch engages.
If the drawer does not stay closed, the
drawer contents may be the obstruction, or
the hook may be bent or it may rub against
the drawer slides. To fix this problem, lightly
bend the hook until the drawer engages in
the slide.
TO REMOVE DRAWERS
Pull the drawer out so it is almost fully
extended. PUSH UP on the black release
lever on one side, while PULLING DOWN
on the black release lever on the other side.
While holding the levers in the positions as
instructed above, pull the drawer outward
until it is released from the drawer slide.
PUSH UP (ONE SIDE)
PULL DOWN (OTHER SIDE)
TO REPLACE DRAWERS
Extend the drawer slides from the tool
chest or cabinet. Insert the brackets on
each side of the drawer into the slots in the
chest or cabinet slides, being careful that
they are positioned properly. Once properly
inserted, completely close the drawer to
set the slides in their proper positions.
ASSEMBLY AND OPERATION