Use And Care Manual

Page 11
OPERATION
3. The variable-speed trigger switch
delivers higher speed with increased
trigger pressure and lower speed with
decreased trigger pressure.
WARNING:
Allow the motor to
come to a complete stop before setting
the drill/driver down.
ELECTRIC BRAKE
To stop the drill/driver, release the trigger
switch and allow the chuck to come to a
complete stop. The electric brake quickly
stops the chuck from rotating. This feature
engages automatically when the trigger
switch is released.
DIRECTION-OF-ROTATION SE-
LECTOR
(FORWARD/CENTERLOCK/
REVERSE) (FIG. 7)
FIG. 7
Reverse
The direction of bit rotation is reversible and
is controlled by a selector located above the
variable-speed trigger switch. With the drill/
driver held in normal operating position:
1. Position the direction-of-rotation
selector to the right of the tool for
reverse rotation.
LED WORKLIGHT (FIG.5)
FIG. 5
The LED worklight, located on the base
of the drill/driver, will illuminate when the
trigger switch is depressed before the drill/
driver is running. This provides additional
light on the surface of the workpiece. The
light will automatically turn off within 10
seconds after trigger is released.
VARIABLE-SPEED TRIGGER
SWITCH (FIG. 6)
FIG. 6
1. To turn the drill/driver ON, press the
variable-speed trigger switch.
2. To turn the drill/driver OFF, release the
variable-speed trigger switch.
LED Worklight
Variable-Speed
Trigger Switch
Forward
Direction-
Of-Rotation
Selector