Use And Care Manual

Page 13
OPERATION
INSTALLING AND REMOVING
THE BELT CLIP (FIG.11)
FIG. 11
To install the belt clip:
1. Align the rib of the clip with the hole on
the base of the drill.
2. Insert the screw and tighten the screw
securely with a screwdriver. The belt clip
can be positioned on either side of the
tool.
To remove the belt clip:
1. Use a screwdriver to loosen the screw
that attaches the belt clip to the drill.
2. Remove the screw and the belt clip.
INSTALLING AND REMOVING
THE BIT HOLDER (FIG.12)
FIG. 12
Bit holder
To install the bit holder:
1. Align the rib of the bit holder the hole on
the base of the drill.
2. Insert the screw (included) and tighten
the screw securely with a screwdriver.
The bit holder can be positioned on
either side of the tool.
To remove the bit holder:
1. Use a screwdriver to loosen the screw
that attaches the bit holder to the drill.
2. Remove the screw and the bit holder.
DRILLING
1. Check that the direction-of-rotation
selector is at the forward setting.
2. Secure the material to be drilled in a vise
or with clamps to keep it from turning as
the drill bit (available separately) rotates.
3. Hold the drill/driver firmly, and place the
bit at the point to be drilled.
4. Depress the trigger switch to start the
drill/driver.
5. Move the drill bit into the workpiece,
applying only enough pressure to keep
the bit drilling. Do not force the drill or
apply side pressure to elongate a hole.
Let the tool do the work.
6. When drilling hard, smooth surfaces,
use a center punch to mark the desired
location of the hole. This will prevent the
drill bit from slipping off-center as the
hole is started.
7. When drilling metals, use light oil on
the drill bit to keep it from overheating.
The oil will prolong the life of the bit and
increase the drilling action.
8. If the bit jams in the workpiece or if the
drill stalls, stop the tool immediately.
Remove the bit from the workpiece and
determine the reason for jamming.
Screw
Screw
Belt clip