Installation Instructions

Page 12
OPERATION
WALL-MOUNT HOLES
(FIG. 3A, 3B, 3C)
The charger has two hanging holes for
convenient storage.
1. Select a location indoors and away from
any objects that could block the vents
on the charger.
2. You will need two screws (not included).
3. Install two screws: Screws should be
installed so that the distance between
their centers is 12 1/8” (308 mm). Use a
level to be sure that the two screws are
aligned vertically.
4. Place the charger into the screws as
shown in Fig. 3a.
FIG. 3A
5. Slowly move the charger to the vertical
position (Fig. 3b).
FIG. 3B
6. Gently lower the charger until the two
screws snap into position. (Fig.3c)
FIG. 3C
NOTICE: The hanging place should be
indoors and away from any objects that
could block vents on charger.