Product Manual

Page 21
USING THE ROUTER WITH THE
ROUTER TABLE
1. Read and understand the entire
Instruction Manual for the router.
2. Always plug the router into the switched
outlet in the router table. Never plug a
router mounted to a router table into
another power source.
3. Make sure that the router-table switch is
off.
4. Plug the router-table cord into a power
source.
5. Turn on the power to the router table by
lifting up the on/off switch panel.
6. Always control the power to the router
with the router-table switch whenever
the router is mounted on the table.
ROUTING OPERATION
1. Read and understand the entire
Instruction Manual for the router.
OPERATION
2. Adjust the fence to support the workpiece
to be cut.
NOTICE: The workpiece must always be
held tight against the fence.
3. Reconfirm that all router adjustments are
securely locked before supplying power
to the router.
4. Note that the direction of rotation of
the router mounted to a router table is
counterclockwise. Feed the workpiece
from right to left.
WARNING:
The direction of feed
for the workpiece is always against the
sharp edges of the cutter and into the
rotation of the cutter (the cutter rotation
is counterclockwise when the router is
installed in a router table). Failure to follow
this rule can result in serious personal
injury.
MAINTENANCE
WARNING:
To ensure safety and
reliability, all repairs should be performed
by a qualied service technician at
Authorized Service Center.
WARNING:
Always wear safety
goggles or safety glasses with side
shields when using compressed air to
clean tool. If the operation is dusty, also
wear a dust mask.
WARNING:
Unplug the router
from the power source before cleaning or
performing any maintenance.
WARNING:
If the supply cord
is damaged, it must be replaced by a
specially prepared cord available through
the service organization.
WARNING:
Do not allow brake
uids, gasoline, petroleum-based
products, penetrating oil, etc. to come
into contact with plastic parts. These
substances contain chemicals that can
damage, weaken, or destroy plastic.
Before each use:
• Inspect the router, the switch, and the
cord for damage.
• Check for damaged, missing, or worn
parts.
• Check for loose screws, misalignment
or binding of moving parts, or any other
condition that may affect the operation.
• If abnormal vibration or noise occurs,
turn the router off immediately, and
have the problem corrected before
further use.