Product Manual

Page 15
3. Loosen three flat-head bolts (U) by
turning them counterclockwise with the
wrench supplied (Fig. 13) and remove all
the flat-head bolts (U).
4. Remove the router from the mounting
plate.
NOTICE: The fence must be removed
from the router table when removing or
reinstalling the router mounting plate.
ATTACHING THE FENCE ASSEM-
BLY TO THE TABLE (FIG. 15)
FIG. 15
Fence-
assembly knob
Hole
WARNING:
Always unplug the
router before attaching or removing
the fence. The fence has been shipped
completely assembled.
1. Loosen the fence-assembly knob.
2. Insert the fence-assembly knobs into
the holes on the router table.
3. Adjust the fence to the desired position
and tighten the fence-assembly knob by
turning it clockwise.
NOTICE: Use the scale on the table as a
guide when aligning the fence for routing
operations. Once the fence is positioned
and aligned correctly, tighten all the
locking knobs securely.
ATTACHING THE MITER GAUGE
(FIG. 16)
FIG. 16
The miter gauge has been shipped
completely assembled.
Attach the miter gauge to the table by
placing the miter-gauge bar in the slot on
the table.
INSTALLING TABLETOP INSERT
RINGS (FIG. 17)
FIG. 17
Blank plate
1-1/4 in.
1-7/8 in.
2-1/8 in.
2-1/2 in.
This router table includes five tabletop
insert rings with the following hole sizes:
• 1-1/4” diameter is for use with bits with
diameters up to 1-1/8”.
• 1-7/8” diameter is for use with bits with
diameters up to 1-3/4”.
• 2-1/8” diameter is for use with bits with
diameters up to 2”.
• 2-1/2” diameter is for use with bits with
diameters up to 2-3/8”.
ASSEMBLY