Product Manual

Page 14
7. Hold the mounting plate with one hand,
and securely tighten each flat-head bolt
(U) with the other hand, using the wrench
(supplied). If your router model is not listed
in Table 2, it may still be installed using
mounting holes A. However, over-the-
table adjustment may not be accessible in
this situation. To mount any router, ensure
that the diameter of the router base does
not exceed 6-7/8 inches.
Table 2: Cutting depth adjustment holes
Mount-
ing holes
Brand Model
A Masterforce 241-0834
241-0835
241-0836
Performax 241-0974
241-1462
241-1463
241-1464
Skil 1817
1827
1830
B
Rigid R2200
Bosch 1617EVS/
MRF23EVS
Dewalt DE618
Porter Cable 9690LR,690LR
C
Porter Cable 7518
Milwaukee 5625-20
INSTALL THE ROUTER
MOUNTING PLATE ON
THE TABLE (FIG. 14)
FIG. 14
Detent
WARNING:
Make sure that the
router is not plugged into a power outlet
when installing into the table, removing
from table, making any adjustments or
changing accessories.
1. Place the router mounting plate, with
the router attached, into the opening in
the table so that it rests on the heads of
the leveling screws.
NOTICE: Be careful not to trap the cord
between the router mounting plate and
the router table.
2. Check the router mounting plate to
be sure that it is level. If necessary,
loosen the plate mounting screws and
adjust the leveling screws, as needed.
Once the router mounting plate is level,
retighten the locking screws.
3. Secure the router mounting plate
to the table with the plate mounting
screws previously removed. Tighten
the mounting plate with the wrench
(supplied).
NOTICE: To adjust the level of the
mounting plate, you should loosen the
mounting screws, and tighten them when
the adjustment is nished. But do not
over-tighten.
NOTICE: Make sure that the mounting
plate surface is lower than the table
surface.
TO REMOVE THE ROUTER
WARNING:
Make sure that the
router is not plugged into a power outlet
when installing into the table, removing
from table, making any adjustments or
changing accessories.
1. Loosen the mounting-plate locking
screws by turning them counterclockwise
with the wrench (supplied) and remove
the four screws (Fig. 10).
2. Remove the mounting plate from the
router table.
ASSEMBLY