Operator`s manual

Page 11
BULB REPLACEMENT (FIG. 5)
1. Remove the battery pack from the
worklight.
2. Rotate the reector counterclockwise
to remove it.
3. Remove the old bulb by rotating it.
4. Insert new bulb by rotating bulb in place.
5. Align the reector and rotate it clockwise
to tighten into place.
WARNING:
ONLY use
recommended replacement bulbs; other
bulbs may cause personal injury.
NOTICE: Use 18V bulbs rated current
larger than 300mA.
MAINTENANCE
PUSH
FIG. 5
To tighten
To loosen
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The worklight does
not illuminate.
Battery is depleted. Charge the battery.
The bulb is broken. Replace the bulb.