Operator`s manual

Page 10
ELECTRIC BRAKE
To stop the right angle drill, release the
trigger switch and allow the chuck to come
to a complete stop. The electric brake
quickly stops the chuck from rotating. This
feature engages automatically when you
release the trigger switch.
LED WORKLIGHT (FIG. 4)
The LED worklight located on the front
of the right angle drill will turn on when
the trigger switch is depressed. The LED
worklight will turn off when the trigger
switch is released. This provides additional
lighting on the surface of the workpiece
for operation in lower light areas.
OPERATION
DIRECTION-OF-ROTATION
SELECTOR (FORWARD/
CENTER LOCK/REVERSE)
(FIG. 3)
The direction of the bit rotation is
reversible and is controlled by a
selector located above the trigger switch.
With the right angle drill held in normal
operating position:
1. Position the direction of rotation
selector to the left of the tool for
forward rotation.
2. Position the direction of rotation selector
to the right of the tool for reverse.
3. Setting the switch in the OFF (center
lock) position helps reduce the
possibility of accidental starting when
not in use.
NOTICE: To prevent gear damage, always
allow the chuck to come to complete stop
before changing the direction of rotation.
NOTICE: The drill will not run unless the
direction of rotation selector is engaged
fully to the left or right.
FIG. 3
FIG. 4
Forward Reverse
LED worklight