Operator`s manual

Page 9
OPERATION
TO ATTACH BATTERY PACK
(FIG. 1)
CAUTION:
When placing the
battery pack in the tool, be sure that the
raised rib on battery pack aligns with the
groove on the drill and the latches snap
into place properly. Improper assembly of
the battery pack can cause damage to
internal components.
CAUTION:
Avoid the possibility of
accidental starting, always take care
not to activate the trigger switch when
you are attaching the battery pack or
performing other adjustments to the tool.
1. Align the raised portion on the battery
pack with the grooves on the bottom of
the right angle drill then attach the
battery pack to the right angle drill as
shown.
2. Make sure that the latch on the battery
pack snaps into place and battery pack
is secured to tool before beginning
operation.
FIG. 1
TO DETACH BATTERY PACK
(FIG. 1)
1. Depress the battery release button
located on the both sides of the battery
pack to release battery pack.
2. Pull battery pack out and remove it from
the tool.
TRIGGER SWITCH (FIG. 2)
To turn the tool ON, depress the trigger
switch.
To turn it OFF, release the trigger.
VARIABLE SPEED (FIG. 2)
The variable-speed trigger switch delivers
higher speed with increased trigger
pressure and lower speed with decreased
trigger pressure.
Variable-speed
trigger switch
Direction-of-
rotation selector
FIG. 2
Battery release
button