Installation Instructions

MAINTENANCE
TOOL MOUNT ADJUSTMENT SCREW
Most plastic tool mounts are designed to fit snugly over the stand rails. With the locking levers
in the lowered (locked) position, you should not be able to remove the saw and tool mount
assembly from the rails. If the saw and tool mount can be removed from the rails when the levers
are locked, the tool mount adjustment screws need to be tightened. If the saw and to,ol mount
assembly will not fit over both rails, the bracket adjustment screws needs to be loosened.
NOTE:The saw should be removed from the tool mounts before attempting to tighten or loosen
the tool mount adjustment screws.
TO ADJUST:
Figure 9.
1. Use a wrench to slightly loosen the nut.
2. Turn the screw with a Phillips screwdriver. Rotate clockwise if the tool mount assembly needs
to be tightened or counterclockwise if the assembly needs to be loosened.
3. Install th,e tool mount on the miter stand rails and lower the locking lever to check the adjustment.
4. When the correct position is achieved, wrench tighten the nut to secure.
5. Repeat with the second tool mount.
FIG 9
Tool Mount
ount
ent Screw
Tool M
Adjustm
GENERAL MAINTENANCE
®
Rapid Clamp Tool Mounts
WARRANTY
90-DAY MONEY BACK GUARANTEE
This MASTERFORCE® brand power tool carries our 90-Day Money Back Guarantee.
If you are not completely satisfied with your MASTERFORCE® brand power tool for
any reason within ninety (90) days from the date of purchase, return the tool with your
original receipt to any MENARDS® retail store, and we will provide you a refund - no
questions asked.
LIMITED LIFETIME WARRANTY
MASTERFORCE® Miter Saw Stands have been manufactured to the highest
standards of quality and workmanship and are warranted to be free from defects in
materials and workmanship under normal use for the lifetime that you own the product.
If any part of the product is found to be defective during normal use, the defective
product or part will be replaced at our discretion. This warranty does not cover products
that are damaged through accident, abuse, misuse, commercial/industrial applications
or neglect. This warranty also does not cover any losses, injuries or costs including
indirect, incidental or consequential damages. This warranty may not be transferred or
sold. When requesting warranty service please call 1-800-288-4695 and have the model
number, cash register receipt and the date of purchase available when you call. If the
product is defective, we will replace the defective part at no cost to you. Some states
do not allow the exclusion or limitation of incidental damages, so the above limitations
or exclu1sions may not apply to you. This warranty gives you specific legal rights and
you may have other rights, which vary from state to state.
For questions/ comments, technical assistance or repair parts -
Please call toll free at:
1-800-288-4695(M-F 8am - 5pm Central Standard Time)
SAVE YOUR RECEIPTS
THIS WARRANTY IS VOID WITHOUT THEM
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use clean cloths to
remove dirt, dust, oil, grease, etc.
Page 10