Installation Instructions

•
FIG 5
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
MOUNTING THE TOOL ASSEMBLYTOTHE STAND TO REMOVE TOOL ASSEMBLY FROM STAND:
Figure 4.
Figure 5.
Use the handles located at the rear of the tool mounts to aid in installing or removing saw and tool
1 . Raise the locking levers to unlock the saw and tool mounts.
mount assembly. 2. Lift away from the rear rail of the stand to disengage .
1. Lift the saw and tool mount assembly, allowing the assembly to tilt slightly toward your body. 3. With the assembly tilted slightly toward you, lift the assembly to disengage from the front rail
2. While still tilted toward you , hook the front edge of the tool mount assembly onto the front rail of the stand.
of the stand.
3. Lower
the tool mount assembly to allow the rear edge of the tool mount to seat fully over the rear rail.
4. Lock the tool mounts in position by lowering the locking levers .
NOTE: Continue to hold the tool mount assembly with one hand until both levers are
securely locked.
1. Check position and adjust, if necessary, to make sure the weight of the saw is evenly
balanced over the rails.
2. Ensure the saw is fully seated and locked in position, then securely tighten the four nuts holding
the saw to the tool mounts.
FIG 4
Page 8 Page 9