Manualshelf

Installation Instructions

ManualsBrandsMasterforce ManualsPower Tool AccessoriesRapid-Clamp Tool Mounts
123456
ASSEMBLY INSTRUCTIONS
ATTACHING YOUR MITER SAW OR OTHER BENCH TOP POWER TOOL
Figure 2.
Various bench top tools can be attached to the Rapid Clamp Tool Mounts.
Always position the saw to achieve maximum balance and stability. All four corners of the saw must be
bolted to the tool mounts before use. Make sure bolts do not extend above the table of the miter saw.
1. Unplug the saw and lock the saw arm in the down position.
2. Place a tool mount underneath the saw, aligning the mounting holes on the miter saw base with
the slot iin the top of the tool mount.
3. Feed a carriage bolt up through both the tool mount and a mounting hole in the saw.
4. Secure in place using a flat washer, lock washer and nut.
5. Repeat through the other end of the tool mount.
6. Place the second tool mount underneath the other side of the saw, aligning the mounting holes
on the miter saw base with the opening in the tool mount.
7. Install carriage bolts as previously described.
8. After making sure both tool mounts are parallel to each other, finger tighten all four nuts to hold
in position.
NOTE: If the saw has holes that do not line u1p with the slots in the tool mounts use the
offset mounting brackets, as seen in Figure 3.
FIG 2
3
4
5
6
I
I
I
0
I
I
n
I
I
I
a
ASSEMBLY INSTRUCTIONS
OFFSET MOUNTING
Figure 3.
Offset Mounting Bracket for Miter Saws and/or Power Tools with an irregular mounting hole pattern.
Instructions: Secure offset mounting brackets as shown. Brackets can be used on the front or rear
of the Rapid Clamp Tool Mounts.
FIG 3
2 Offset Mounting Brackets
0
Page 6
Page 7