Installation Instructions

a
PARTS LIST SAFETY
GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS
Using power tools of any kind can be dangerous if safe operating procedures are not followed.
Recognizing the hazards of each tool and using them with respect and caution will considerably
limit the possibility of personal injury. However, if safety precautions are ignored, personal injury
will likely result. Always use common sense - your personal safety is your responsibility.
1. Know your power tool. Read and understand the Operator's Manual and observe the warnings
and instruction labels affixed to the tool.
2. Properly ground all tools.
3. Keep guards in place.
4. Remove adjusting keys and wrenches.
5. Keep work area clean and dry.
6. Keep children away.
7. Never leave running 1machines/tools unattended.
8. Disconn1ect tools from service.
9. Use correct tools for the job.
10. Never force a tool.
11.Wear safety apparel.
12. Wear safety glasses/goggles.
13. Never stand or sit on tools.
14. Replace damaged components immediately.
15. Make sure your work platform is sufficiently sturdy to do the specific job at hand.
16.Properly anchor blade for job being done.
17. Use correct blade for job being done.
18.Think Safety. Safety iis a combination of operator awareness, common sense and alertness at
all times.
SAFETY INSTRUCTIONS FOR MITER SAW STANDS
1. Use caution when folding or unfolding legs to limit any finger pinch points.
2. Place stand on flat and level surface to keep from rocking or tipping.
3. Make sure that work support extensions are within safe operating limits, and are properly
locked in place before using tool. Do not exceed the maximum weight of your miter saw stand.
4. Test the setup for stability before proceeding with work.
5. Be sure the miter saw is tightened securely at all mountings before use or folding the stand
for transport.
Description Part Number Qty
1 Rapid Clamp Tool Mount MF-MMA-01004A 1 set
2 Offset Mounting Bracket MF-MMP-01001 A 2 pcs
3 Nut M8 MF-MMP-01011 A 6 pcs
4 Spring Washer #8
MF-MMP-01014A 6 pcs
0
0 0
OVERVIEW
You have just purchased a set of Rapid Clamp Tool Mounts. This product has been specifically
dlesigned to assist you in the use of your
10-12" miter saw, as well as increasing efficiency with
other bench top tools such as table saws, band saws, scroll saws, planers, etc.
FIG 1
1 Rapid Clamp Tool Mounts
Description Part Number
Qty
5 Washer#8 MF-MMP-01013A 6 pcs
6 Carriage Bolt M8*50
MF-MMP-01012A 4 pcs
7 Carriage Bolt M8*20 MF-MMP-0101 0A 2 pcs
Page4 Page 5