Product Manual

Page 12
INSTALL STRING IN THE STRING
HEAD
1. Line up the slots on the spool cap with the
slots on the string head.
2. Insert line through the string head hole.
Push line until it exits the opposite string
head hole.
3. Pull the line through until there is an equal
amount of line on each side.
4. Turn the spool cap clock-wise to begin
winding the string into the string head. Leave
approximately 5 inches of string protruding
out of each side of the head.
It is recommended that 0.080” line Diameter
be used for this string head.
Note: Do not put more than 15 feet of line in
at a time.
REMOVE THE OLD TRIMMER
LINE
1. Firmly press in the tabs on each side of the
spool cover.
2. Remove the spool cover from the spool
housing.
3. Remove any excess trimmer line or
obstructions from the spool.
4. Use a clean cloth to wipe away any debris
from the spool, spool cover, or spool
housing.
5. Align the tabs of the spool cover with the
posts on the spool housing. Push the spool
cover until the tabs securely snap into
the posts.
OPERATION