Instruction manual

The Interface connector is fitted at right side of printer. This is 6pins RJ connector for RS-232C
Communication.
2-1-4.Belt rack holes
There are two holes in the base of the printer which allow the printer to be attached to vertical
Surface Such as a wall or waistband.
2-1-5.Sensors
The HANDY700 Printer is fitted with three sensors.
The DOOR –CLOSED SENSOR is to avoid the damaging the print-head, When the door is open.
The END-OF-PAPER SENSOR(EOP) detects the presence of paper near to the print-head.
To avoid damage the print-head, When no paper is detected.
The Infrared IrDA SENSOR is fitted on the front panel. This sensor is used to interface with
Infrared communication.
2-2.Paper specification.
Paper width : 57mm
Maximum paper roll diameter : 40mm
Maximum paper thickness : 60gsm
Emulsion(sensitive) side : On out side of roll.
Recommended paper : Mitsubishi,P220AG
2-3.Power supply.
2-3-1. Adapter :
The Internal battery charging adapter is a DC12V and current capacity of 1A or more.
External Direct power supply is DC12V and current capacity 2.5A or more.
It packs a DC JACK type connector in which the inner contact is with
External diameter(3.5mm),Internal diameter(1.3mm),length(10mm).