SDS

SECTION XIII - CONSIDERATIONS ON WASTE DISPOSAL
Disposal of wastes
This product does not generate wastes considered to be hazardous in the country of origin.
It’s possible to incinerate these wastes or dispose at a rubbish dump according to regulations
in the country of destiny.
The usage of cutting tools with high revolutions or router cutting may generate high dust
concentration. The dust could present an explosion risk if it, in high concentrations, comes in
contact with sparks (depending of the particle size and its’ humidity).
Combustion of boards or sanding dust may generate carbon dioxide, carbon monoxide, nitrogene
oxide and other pirolysis products.
SECTION XIV - TRANSPORTATION INFORMATION
This product is not a risky material.
SECTION XV - INFORMATION ON REGULATIONS
OSHA
Wooden products are not a risk under certain criterias according to denitions in
OSHA Standard 29 CFR 1910.1200. However, the sanding dust generated in cutting, sanding
or machinery processing may be a risk to an allergic person.
SECTION XVI - OTHER INFORMATION
The information herein is given in good faith, but does not guarantee that no problems will occur if this depends on the use given
to the product.
CLAIMS
The information contained in this “PRODUCT SAFETY SHEET” is based on dates being precise and correctly determined at the time,
and have been compiled using information sources created for these objectives.
The client assumes all usage and storing risks of this product according to federal and/or local laws applying in the usage place of the
product. It is the client’s direct responsibility to investigate and know the safe methods for disposal and storing of these products.
All information contained in this document may be applied under conditions out of our control, but no responsibility can be accepted
by us in case of any loss or damage caused to any person as a result of this information.
SECTION XII - ECOLOGICAL INFORMATION
Product type When the boards are kept in well ventilated areas, the formaldehyde emission is very low.
Spillages/Procedures in case of leaking
Precautions to be considered
during handling and storing.
Providing adequate ventilation reduces the possibility of formaldehyde
gases in constructions.
Steps to follow in case of spillages Incinerate or dispose in places according to the existing regulations.
www.arauco.cl
PAGE
05 of 05
VERSION
05
Material Safety Data Sheet
PREPAINTED MDF
MOULDING
Reference:HDSMouldings
Date :06.13.2006
Section :MTSA
QUALITY CONTROL DEPT.