User Manual

model no. 058-8194-4 | contact us 1-800-689-9928

ASSEMBLY INSTRUCTIONS

BEFORE YOU START—DESCRIPTION

2. Extension cord

3. Install the wire roller

Drive tension arm

Gun liner

Drive roller

Drive tension arm

Connect your welder’s power cord to a properly grounded 120-V AC, 60-Hz,

single-phase, 20-A power source.

Before installing any welding wire into the unit, the properly-sized groove must be positioned

on the wire drive mechanism. Adjust the drive roller according to the following steps, see

following picture about the wire feeder structure:

During normal use an extension cord is not necessary. It is strongly recommended that an

extension cord should not be used because of the voltage drop they produce. This drop in

voltage can affect the performance of the welder. If you need to use an extension cord it must

be a #12 gauge cord at the least..

Do not use an extension cord over 25' (7.6 m) in length.

Inlet guide tube

3.1. Open the door to the welder drive compartment.

3.2. Remove the drive tension (see 1) by loosening the tension adjusting knob and lifting the

drive tension adjustor away from the drive tension arm (see 2). Pull the drive tension arm

away from the drive roller (see 3). See following images for reference.

3.5. Pull the drive roller off of the drive roller shaft.

3.3. If a wire is already installed in the welder, roll it back onto the wire spool by hand-turning

the spool counter-clockwise. Be careful not to allow the wire to come out of the rear end of the inlet

guide tube without holding onto it or it will unspool itself. Put the end of the wire into the hole on the

outside edge of the wire spool and bend it over to hold the wire in place. Remove the spool of wire

from the drive compartment of the welder.

3.4. Rotate the drive roller cap counter-clockwise and remove it from the drive roller.

AC single-phase 120 V (110

130 V), 60 Hz fused with a 20-A time-delayed fuse or circuit breaker is

required. DO NOT OPERATE THIS UNIT if the ACTUAL power source voltage is less than 105 V AC

or greater than 132 V AC.

1. Power requirement

ASSEMBLY INSTRUCTIONS

model no. 058-1294-8 | contact us 1-800-689-9928model no. 058-1294-8 | contact us 1-800-689-9928model no. 058-1294-8 | contact us 1-800-689-9928

Model no. 058-1926-6 | contact us 1-800-689-9928