User Manual

4 5
model no. 058-8194-4 | contact us 1-800-689-9928
SAFETY GUIDELINESSPECIFICATIONS
Please read and save these instructions. Read through this owner’s manual carefully before using product.
Protect yourself and others by observing all safety information, warnings, and cautions.
WARNING!
In order to avoid mistakes that could cause serious injury, read the following steps carefully and
understand them thoroughly before using this welder.
1 Keep the environment you will be welding in free from flammable materials.
2 Always keep a fire extinguisher accessible to your welding environment.
3 Always have a qualified person install and operate this equipment.
4 Make sure the area is clean, dry and ventilated. Do not operate the welder in humid, wet or poorly
ventilated areas.
5 Always have your welder maintained by a qualified technician in accordance with local, provincial
and national codes.
6 Always be aware of your work environment. Be sure to keep other people, especially children, away
from you while welding.
7 Check all components to ensure they are clean and in good operating condition before use.
8 Do not operate the welder if the output cable, wire, or any part of the system is wet.
9 Do not immerse them in water.
10 Do not allow any body part to come into contact with the wire if you are in contact with the
material being welded, ground or wire from another welder.
11 Do not weld if you are in an awkward position. Always have a secure stance while welding to
prevent accidents. Wear a safety harness if working above ground.
12 Do not drape cables over or around your body.
13 Wear a full-coverage helmet with shade (see ANSI Z87.1 safety standard) and safety glasses while
welding.
14 Wear proper gloves and protective clothing to prevent your skin from being exposed to hot metals,
UV and IR rays.
15 Do not overuse or overheat your welder. Allow proper cooling time between duty cycles.
16 Always use this welder in the rated duty cycle to prevent excessive heat and failure.
17 Do not attempt to repair or maintain the welder while the power is on.
18 Do not touch the wire and the ground or grounded work piece at the same time.
19 Do not use a welder to thaw frozen pipes.
Model number 058-1926-6
Power 120 V, 60 Hz, 1 Phase
Voltage 42 V (no load)
30–125 AOutput current
Duty cycle 30% at 90 A
Suggested wire Flux-cored wire
Wire Diameter 0.030 and 0.035" (0.8 and 0.9 mm)
Dimensions (L x W x H)
12 3/8 x 5 11/16 x 10 13/16'' (31.5 x 14.5 x 27.5 cm)
Net weight 14 lb 14 oz (6.75 kg)
model no. 058-1294-8 | contact us 1-800-689-9928model no. 058-1294-8 | contact us 1-800-689-9928model no. 058-1294-8 | contact us 1-800-689-9928
Model no. 058-1926-6 | contact us 1-800-689-9928
SPECIFICATIONS
SAFETY GUIDELINES