User Manual

headline bars
continuation tabs
notes
warnings
17
PLANING WITH THE EDGE GUIDE
The edge guide can be used to control the width of the
cut or for simply providing added stability and protection
when cutting materials that are up to 3-1/4" (82 mm)
wide (fig 12).
CHAMFERING (fig 13)
The “V” groove in the front base allows quick and easy
chamfering of workpiece edges.
1. Place the “V” groove on the front base over the edge
to be chamfered. Be sure the blades are not touching
the workpiece.
2. Position the “V” groove absolutely flat on the edge to
be beveled.
3. Grasp the tool firmly with both hands, turn the tool on
and push the planer forward with steady pressure on
the front base.
WARNING!
• Hold the tool with both hands while starting the tool, since torque from the motor can
cause the tool to twist.
FPO
fig 13
fig 12
12.7 mm
max
82 mm
max
OPERATING INSTRUCTIONS