Installation Instructions

ManualsBrandsMastercraft ManualsDoors72"W x 80"H Primed Steel Internal Blind Full Lite Center Swing Patio Door - Right Inswing

WARNING

Door Units Are Heavy! Use an adequate number of people to set the unit and prevent injuries or damage to the door.

Note: These instructions are recommended installation methods and not a substitute for local building codes. Please consult your local building

codes prior to any door installation.

Summary of content (4 pages)

PAGE 1
WARNING Door Units Are Heavy! Use an adequate number of people to set the unit and prevent injuries or damage to the door. Note: These instructions are recommended installation methods and not a substitute for local building codes. Please consult your local building codes prior to any door installation.
PAGE 2
DOOR SYSTEM CENTER HINGE PATIO DOOR 3) Setting the Door Unit fig. 7 fig. 6 fig. 9 a) Apply three beads of Silicone caulking to the sub-floor of the rough opening (fig.6). b) Apply a second bead of caulking around the perimeter of the door sill (fig.7). c) Apply a bead of caulking around the backside perimeter of the door’s brickmould (fig.8 ). d) Using two people, set the sill into the rough opening. Center the frame into the opening and tip the unit into place (fig.9). fig.
PAGE 3
DOOR SYSTEM CENTER HINGE PATIO DOOR 6) Fastening the Inactive Door Jamb a) Re-check for plumb on the inactive side of the door (fig.18). Using a ¹⁄8" drill bit, predrill a ¹⁄8" hole at a 45º angle, through the jamb and into the shim location (fig.19). b) Using a countersink bit, countersink the holes drilled in figure 20 in order to allow the screw heads to sit flush with the jambs (fig.20).
PAGE 4
DOOR SYSTEM CENTER HINGE PATIO DOOR 9) Insulating the Door Unit Before applying casing to the interior of your door unit you will need to insulate around the frame opening. We recommend using “Fiberglass Blanket Insulation”. Do not use expanding foam, it will affect the margin around the door unit (fig.30). fig. 30 10 ) Final Installation fig. 31 It is very important that you finish your door system properly. To ensure maximum efficiency, please caulk at the following locations: fig.