Safety Data Sheets (SDS)

Skin Protection
Respiratory Protection
Eye/Face Protection
Respirators are not normally required if the product is used with minimal disturbance and minimal dust is generated.
The following respirator requirements are recommended for dusty conditions.
If the product is disturbed (e.g., cutting, sanding): wear a minimum half facepiece respirator with P100 cartridges for
protection against wood dusts and their applicable exposure standards. Wear a half facepiece respirator for
protection up to 10 times the exposure standard and a tight fitting full facepiece respirator for protection up to 50
times the exposure standard.
Recommendations apply only to NIOSH approved respirators.
Consult an Industrial Hygienist for respirator decisions depending on work environment.
Wear gloves when handling product as directed. Based on wood dust: wear protective clothing and gloves (e.g.,
cotton coveralls and leather / cotton gloves) depending on the work environment.
Not required if product is used as directed. Wear safety glasses with side shields or goggles if dusty conditions exist
depending on the work environment.
pH Not applicable
Appearance Light brown - yellow.
Partition Coefficient,
n-Octanol/Water (Log Kow)
Not applicable
Odour Not available
Vapour Pressure Not applicable
Odour Threshold Not available
Vapour Density (air = 1) Not applicable
Initial Boiling Point/Range Not applicable
Evaporation Rate Not applicable
Flash Point Not applicable
Melting Point/Freezing Point Not applicable (melting); Not applicable (freezing)
Relative Density (water = 1) < 1
Solubility Insoluble in water; Not available (in other liquids)
Auto-ignition Temperature 204 - 260 ºC (399 - 500 ºF)
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
Molecular Formula Not available
Molecular Weight Not available
Not availableDecomposition Temperature
Viscosity Not applicable (kinematic); Not applicable (dynamic)
Critical Temperature Not available
Other Physical Property 1 Lower Explosive Limit: 40 g/m³ (wood dust); Upper Explosive Limit: Variable
(wood dust)
Other Physical Property 2 The autoignition temperature, LEL and UEL for wood dust vary with exact
composition, particle size, moisture level, rate of heating and dust concentration.
Basic Physical and Chemical Properties
SolidPhysical State
Other Information
Flammability (solid, gas) Not available
SDS No.:
Date of Preparation:
005 Page
of
1105
June 10, 2015
Product Identifier: Westpine MDF