Safety Data Sheets (SDS)

Individual Protection Measures
Skin Protection
Respiratory Protection
Eye/Face Protection
Respirators are not normally required if the product is used with minimal disturbance and minimal dust is generated.
The following respirator requirements are recommended for dusty conditions.
If the product is disturbed (e.g., cutting, sanding): wear a minimum half facepiece respirator with P100 cartridges for
protection against wood dusts and their applicable exposure standards. Wear a half facepiece respirator for
protection up to 10 times the exposure standard and a full facepiece respirator for protection up to 50 times the
exposure standard.
Recommendations apply only to NIOSH approved respirators.
Consult an Industrial Hygienist for respirator decisions depending on work environment.
Not required if product is used as directed. Based on wood dust: wear protective clothing and gloves (e.g., cotton
coveralls and leather / cotton gloves) depending on the work environment.
Not required if product is used as directed. Wear safety glasses with side shields or goggles if dusty conditions exist
depending on the work environment.
(e.g. substitution of a less hazardous material).
Do not allow dust from the product to accumulate in the air in work or storage areas, or in confined spaces.
Exhaust dust directly to the outside through explosion proof ducting / ventilation systems, taking any necessary
precautions for environmental protection.
If engineering controls, administrative controls and work practices are not effective in controlling exposure to dust from
this product, then wear suitable personal protective equipment including approved respiratory protection.
pH Not applicable
Appearance Light brown - yellow.
Partition Coefficient,
n-Octanol/Water (Log Kow)
Not applicable
Odour Not available
Vapour Pressure Not applicable
Odour Threshold Not available
Vapour Density (air = 1) Not applicable
Initial Boiling Point/Range Not applicable
Evaporation Rate Not applicable
Flash Point Not applicable
Melting Point/Freezing Point Not applicable (melting); Not applicable (freezing)
Relative Density (water = 1) < 1
Solubility Insoluble in water; Not available (in other liquids)
Auto-ignition Temperature 204 - 260 ºC (399 - 500 ºF)
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
Molecular Formula Not available
Molecular Weight Not available
Not availableDecomposition Temperature
Viscosity Not applicable (kinematic); Not applicable (dynamic)
Basic Physical and Chemical Properties
SolidPhysical State
Other Information
Flammability (solid, gas) Not available
SDS No.:
Date of Preparation:
004 Page
of
1205
March 10, 2016
Product Identifier: Ranger MDF